2002 500SL hood release cable
#1
2002 500SL hood release cable
Has anyone replaced the hood release cable on their 500SL? Getting the rubber bellows firewall seal out and replaced looks like a ghastly job. The fuse box and hood hinge cover virtually obscure it. It cannot, at least by me, be seen from under the dash, again hidden by the E brake assembly and wiring etc. Maybe it's an easier job on a 300SL.
Reed Mayer
Reed Mayer
Last edited by reed mayer; 01-28-2011 at 06:16 PM.
#2
Hah!
I wedged a paint stick between the fuse box and the hood hinge cover to open the gap and better reveal the rubber seal. I then used long needle nosed pliers to reach down and pull the seal out. The widened gap should make installing the new cable and seal easier as well.
Reed Mayer
I wedged a paint stick between the fuse box and the hood hinge cover to open the gap and better reveal the rubber seal. I then used long needle nosed pliers to reach down and pull the seal out. The widened gap should make installing the new cable and seal easier as well.
Reed Mayer
Thread
Thread Starter
Forum
Replies
Last Post