W176 M270.910 1.6 Engine Timing Marks (Cam to Sprockets)
Thread Starter
|
Junior Member
Joined: May 2020
Posts: 1
W176 M270.910 1.6 Engine Timing Marks (Cam to Sprockets)
Am rebuilding the engine of 2013 A180 BlueEffecncy, but this engine does not have an apparent timing marks in referance to camshaft and sprockets (Adjusters) with each other.
the cam have an arrow and the rear of sprockets have several marks at different locations. its not clear if the arrow should line up with what mark, its puzzling me.
Generlly speaking older mercs sprocket slides over a key or a pin locator. this is not the case here, the sprocket has no physical connections to the cam.
i wonder if any of our members has knowledge as how to reattach with correct position. i would appreciate any assistance. thank you
the cam have an arrow and the rear of sprockets have several marks at different locations. its not clear if the arrow should line up with what mark, its puzzling me.
Generlly speaking older mercs sprocket slides over a key or a pin locator. this is not the case here, the sprocket has no physical connections to the cam.
i wonder if any of our members has knowledge as how to reattach with correct position. i would appreciate any assistance. thank you
Junior Member
Joined: Sep 2023
Posts: 1
Am rebuilding the engine of 2013 A180 BlueEffecncy, but this engine does not have an apparent timing marks in referance to camshaft and sprockets (Adjusters) with each other.
the cam have an arrow and the rear of sprockets have several marks at different locations. its not clear if the arrow should line up with what mark, its puzzling me.
Generlly speaking older mercs sprocket slides over a key or a pin locator. this is not the case here, the sprocket has no physical connections to the cam.
i wonder if any of our members has knowledge as how to reattach with correct position. i would appreciate any assistance. thank you
the cam have an arrow and the rear of sprockets have several marks at different locations. its not clear if the arrow should line up with what mark, its puzzling me.
Generlly speaking older mercs sprocket slides over a key or a pin locator. this is not the case here, the sprocket has no physical connections to the cam.
i wonder if any of our members has knowledge as how to reattach with correct position. i would appreciate any assistance. thank you
Thread
Thread Starter
Forum
Replies
Last Post