3.0L CDI v6(2006)valve timing diagram and help required
Thread Starter
|
Junior Member
Joined: Aug 2010
Posts: 1
3.0L CDI v6(2006)valve timing diagram and help required
Hi to everyone out there. ive just joined the forum to see if anyone can help with an R320 cdi (2006) 3.0 L v6 engine i have just rebuilt that was flood damaged and had bent a rod.
ive rebuilt engine but think i have the cam timing a tooth out possibly as the car is now very hard to start and smoke white smoke and flooding causing slow cranking?
have stripped cam covers and chain covers back off and set cams to dots and crank to tdc but the marks always seem half a mark out after turning crank a couple of turns.
i dont want to rebuild until i am 100 per cent sure everything is A1.
cheeers keeny
ive rebuilt engine but think i have the cam timing a tooth out possibly as the car is now very hard to start and smoke white smoke and flooding causing slow cranking?
have stripped cam covers and chain covers back off and set cams to dots and crank to tdc but the marks always seem half a mark out after turning crank a couple of turns.
i dont want to rebuild until i am 100 per cent sure everything is A1.
cheeers keeny
Last edited by keeny; Aug 17, 2010 at 04:08 PM.
Thread
Thread Starter
Forum
Replies
Last Post
