Electric Switch Problem
Thread Starter
|
Junior Member
Joined: Oct 2012
Posts: 2
Electric Switch Problem
Hello All.
If any one can share the information about : Mercedes 1989 260 E Sedan.
I had to separate electrical-switch portion from the Start/ignition switch assembly( Key portion ).
The electrical switch has seven pins( male part ),the female part seven sleeves are connected to seven wires/harness.
Each pin is identified by a number/letter, but the sleeves on the wire ends are without ant identifier ?
Now I do not know which pin should fit in which sleeve/wire end, because there is indication on sleeve /wire end.
I have checked the wiring diagram but no help,I was wondering if some one has some experience/information and can help me .
Thanks.
If any one can share the information about : Mercedes 1989 260 E Sedan.
I had to separate electrical-switch portion from the Start/ignition switch assembly( Key portion ).
The electrical switch has seven pins( male part ),the female part seven sleeves are connected to seven wires/harness.
Each pin is identified by a number/letter, but the sleeves on the wire ends are without ant identifier ?
Now I do not know which pin should fit in which sleeve/wire end, because there is indication on sleeve /wire end.
I have checked the wiring diagram but no help,I was wondering if some one has some experience/information and can help me .
Thanks.
Thread
Thread Starter
Forum
Replies
Last Post