HELP - changed CPS and won't start at all now
Thread Starter
|
Junior Member
Joined: Apr 2010
Posts: 15
HELP - changed CPS and won't start at all now
1993 190e 2.6
Runs until hot then studders and quits at idle -won't restart until cold.
Installed new crankcase position sensor (Bosch 0 251 210 49) and engine won't start at all. Still starts with old sensor.
New CPS sensor measures 850 ohms. I've heard there may be two different sensors with different output...are these matched to the ignition module?
Suggestions please...going nuts over this. Some have even suggested the coolant temp sensor can cause this problem but that makes no sense.
What is going on? Why won't the new sensor work? Help please.
Runs until hot then studders and quits at idle -won't restart until cold.
Installed new crankcase position sensor (Bosch 0 251 210 49) and engine won't start at all. Still starts with old sensor.
New CPS sensor measures 850 ohms. I've heard there may be two different sensors with different output...are these matched to the ignition module?
Suggestions please...going nuts over this. Some have even suggested the coolant temp sensor can cause this problem but that makes no sense.
What is going on? Why won't the new sensor work? Help please.
Thread
Thread Starter
Forum
Replies
Last Post
flainn
Diesel Discussions
4
May 2, 2012 10:55 AM
bright rider
Mercedes C Class
0
Sep 12, 2008 02:03 PM
