W203 Tech - Belt Tensioner Issues? Parts In Stock Now! by Pelican Parts
#1
W203 Tech - Belt Tensioner Issues? Parts In Stock Now! by Pelican Parts
The V-belt tensioner provides a constant tension on the belt which is needed to run all of the engine accessories. Over time the tensioner can fail to maintain the proper tension and the belt will start to slip. If this happens it will usually make a squealing noise. The tensioner can also fail by the bearing wearing out - this will cause the belt to wear unevenly and fray along the edges. You should check your tensioner and V-belt every six months for wear, cracking, fraying, delaminating and drying out. If the tensioner is loose or you can wiggle it or if your belt shows any of these signs you should replace them.
Shop now for replacement belt tensioners for your W203 car - Click HERE
Tools required: E10, E12 Torx driver
Applicable Models:
C320 (1998-2004)
E320 (1998-2004)
S320 (1998-2005)
ML320 (1998-2003)
CLK320 (1998-2004)
SLK320 (1998-2003)
This project takes about an hour.
Pelican Parts
Shop now for replacement belt tensioners for your W203 car - Click HERE
Tools required: E10, E12 Torx driver
Applicable Models:
C320 (1998-2004)
E320 (1998-2004)
S320 (1998-2005)
ML320 (1998-2003)
CLK320 (1998-2004)
SLK320 (1998-2003)
This project takes about an hour.
Pelican Parts
Thread
Thread Starter
Forum
Replies
Last Post
PelicanParts.com
Vendors Special Buys
0
07-03-2013 11:31 AM
PelicanParts.com
Vendors Special Buys
0
06-17-2013 12:59 PM
PelicanParts.com
Vendors Special Buys
0
06-05-2013 12:46 PM
PelicanParts.com
Vendors Special Buys
0
05-08-2013 11:50 AM
PelicanParts.com
Vendors Special Buys
0
05-02-2013 06:57 PM