I am about to order a set of H&R lowering springs for my 2002 C320. I think that the drop should be from 1.5 to 2.0. I have 19 inch rims on the car now. Does anyone know how the drop would look and how difficult the install is? I am tired of seeing so much gap in the wheel wells!

 

post some pics when it is done

 

unless you have a spring compressor do not attempt to install them. Also if you have a compressor be very careful.

 

Also make sure that you align the vehicle after installation and take it for a very good test drive and "REDEFINE" how your car handles, as your turning radius may be changed.