Diesel Discussions Only diesel topics should be posted here.

87 300TDT Overheating issues

Thread Tools
 
Search this Thread
 
  #1  
Old 09-05-2011, 01:51 AM
hooverfull's Avatar
Junior Member
Thread Starter
Join Date: May 2011
Location: San Francisco
Posts: 17
Default 87 300TDT Overheating issues

My Wagon has been having issues with running a little warm, but my mechanic swears it should be running at around 90. When I put a load on it, particularily uphills, the temperature would go up to about 100. If the uphill is long, then the temp even higher, sometimes even reaching 110. I changed the fan clutch and the radiator, and it still runs a little hot, about 90 on the freeway, I was going about 80mph and outside temp was about 80 farenheit. This was driving from SF to Los Angeles. about 400 miles.

Tonight, my wife was driving in about 65-69 f outside temperature and the car really did overheat, went to almost 120, I hope she didn't crack the head... I verified with my mechanic that he replaced coolant from the hose and the reservoir. Thermostat? Water pump? Advice? How do I check the water pump?
 

Last edited by hooverfull; 09-05-2011 at 02:02 AM.
  #2  
Old 09-05-2011, 05:53 PM
Sour Diesel's Avatar
Junior Member
Join Date: Aug 2011
Posts: 3
Default

I have a 84 300 TD and had a similar problem, and I was able to fix it with a new cap to the radiator expansion tank
 
  #3  
Old 09-06-2011, 03:51 AM
Sour Diesel's Avatar
Junior Member
Join Date: Aug 2011
Posts: 3
Default

The cap is only a 5 dollar part that can contribute to the problem
 

Last edited by ForcedInduction; 09-06-2011 at 04:03 AM. Reason: Removed rule violations.
  #4  
Old 09-14-2011, 11:25 AM
oldrebuiltdodge's Avatar
Senior Member
Join Date: Mar 2011
Posts: 178
Default

Forced is right, over heating comes from poor circulation ( stuck t-stat, worn out water pump, plugged radiator, or low coolant level) All the cap does is raise the boiling point of the coolant by holding pressure on the system.
 
  #5  
Old 09-17-2011, 10:27 PM
benzguy's Avatar
Member
Join Date: Jun 2009
Location: Darwin Australia and Vancouver Canada
Posts: 36
Default

^^^^^Yep!
 
  #6  
Old 09-20-2011, 12:22 AM
oldrebuiltdodge's Avatar
Senior Member
Join Date: Mar 2011
Posts: 178
Default

To adderess the overheating issue first posted, I would look first at the thermostat. When it goes up suddenly, it is usually the thermostat not opening all the way up, since you didn't mention coolant all over the engine bay I wouldn't think it was a burst hose causing sudden loss of coolant. If it didn't over heat any before the problem started, then it probably isn't a blown out head gasket, or a cracked head.
 
  #7  
Old 10-28-2011, 12:03 PM
hooverfull's Avatar
Junior Member
Thread Starter
Join Date: May 2011
Location: San Francisco
Posts: 17
Default

OK, still trying to diagnose the problem. The tricky thing is when I bought the car, it came with a WVO system, which I bypassed the fuel from going through. Meaning, coolant is still running through the system. Could this be contributing to the high temp issues?

I think the only thing I did not change out is the electric fan and water pump. How does the electric fan work? I have not seen it turn on yet, so I suspect that may be the problem.

When I go up the grapevine, which is a pretty steep grade where 18 wheelers trudge along at 30mph, my car gets pretty high in temp, even getting up to about 115 C. Way too high? Could my temp guage be off? Engine doesn't struggle though.

Any suggestions on how to diagnose this would be helpful. Could air be in the system? How to bleed air in the system? Sorry for the random thoughts, just thinking it through with the forums.
 
  #8  
Old 11-01-2011, 09:16 AM
oldrebuiltdodge's Avatar
Senior Member
Join Date: Mar 2011
Posts: 178
Default

Getting hot under a load is an indication that the fuel supply is too lean, or the cylinder compression is falling off. Run a compression check and maybe a cylinder leakdown check, also check injector pump output. It still could be the water pump as well. You can check your temp. sender by putting it in water on a hot plate with a thermometer and watching the change in resistance with an ohm meter. The only way I know to get the proper ohm reading is to heat up a known good one with it.
 
  #9  
Old 11-01-2011, 09:19 AM
oldrebuiltdodge's Avatar
Senior Member
Join Date: Mar 2011
Posts: 178
Default

As an after thought you might check coolant flow through the radiator.
 
  #10  
Old 11-04-2011, 09:51 AM
oldrebuiltdodge's Avatar
Senior Member
Join Date: Mar 2011
Posts: 178
Default

oops!! My mistake, half asleep when writing that
 


Quick Reply: 87 300TDT Overheating issues



All times are GMT -5. The time now is 09:40 PM.