Ignition switch woes
#1
Ignition switch woes
1988 W124 260E
So I drove the car to work this morning and turned it off then removed the key. I noticed it was a little 'crunchy' as I pulled the key out so I tried putting it back in and no way is it going back in! What the heck is going on here? Any suggestions what I might do at this point? Thanks...
So I drove the car to work this morning and turned it off then removed the key. I noticed it was a little 'crunchy' as I pulled the key out so I tried putting it back in and no way is it going back in! What the heck is going on here? Any suggestions what I might do at this point? Thanks...
#2
Hello - take a look at the link below to one of our site's DIY tech articles on the W124. You may need to replace the ignition switch, it seems that this issue has been documented before on the W124 platforms.
https://www.pelicanparts.com/techart...eplacement.htm
https://www.pelicanparts.com/techart...eplacement.htm
#4
Glad it worked out for you. Please let us know if we can assist with anything else.
Thread
Thread Starter
Forum
Replies
Last Post