Cannot move 2003 ML500 with no brake pedal pressure.
#1
Cannot move 2003 ML500 with no brake pedal pressure.
Hi folks:
After sitting for a few days, the brake pedal went to the floor when I attempted to take the transmission out of park. I found no obvious evidence of a brake fluid leak, and I filled the reservoire, but I cannot pump up any brake pressure. I cannot take the transmission out of park with no brake pressure, so I cannot move the vehicle.
Is there any way I can get it into neutral so I can have it towed, or trailored to a garage?
Thanx
After sitting for a few days, the brake pedal went to the floor when I attempted to take the transmission out of park. I found no obvious evidence of a brake fluid leak, and I filled the reservoire, but I cannot pump up any brake pressure. I cannot take the transmission out of park with no brake pressure, so I cannot move the vehicle.
Is there any way I can get it into neutral so I can have it towed, or trailored to a garage?
Thanx
#3
Thankyou ForcedInductiion:
I pumped the pedal by hand and immediately got pressure. Then I found a fresh puddle of fluid on the ground, about a foot ahead of the left rear wheel.
Is there an easy way I can isolate that line so I can drive the car to the garage?
I pumped the pedal by hand and immediately got pressure. Then I found a fresh puddle of fluid on the ground, about a foot ahead of the left rear wheel.
Is there an easy way I can isolate that line so I can drive the car to the garage?
Thread
Thread Starter
Forum
Replies
Last Post
Andrijam
General Tech
0
12-04-2013 01:47 PM
kompressorfla
Mercedes S Class
3
11-18-2006 06:23 AM